Send break to enter eeprom.
delete flash:private-multiple-fs
reset
*reload*
Login:
Username: Cisco
Password: Cisco
Wait for the capwap prosess to start.
APlolf.0oba.rlol>enable
Password: capwap process not yet started.Please execute enable command again.
Look for this message: “*Mar 1 00:15:26.735: %LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio1, changed state to up”
Try again:
APlolf.0oba.rlol>enable
Password:
APlolf.0oba.rlol#
Success!
debug capwap console cli
debug capwap client no-reload
configure terminal
ip default-gateway 10.0.0.5
interface GigabitEthernet0
ip address 10.0.0.2 255.255.255.0
no shutdown
archive download-sw /overwrite /reload tftp://10.0.0.3/c1140-k9w7-tar.152-4.JB6.tar
*reload*
line vty 0 4
login local
exit
line console 0
login local
username Cisco privilege 15 password Cisco
hostname AIR-LAP1142N-E-K9
dot11 ssid Wireless Network
authentication open
authentication key-management wpa ver 2
wpa-psk ascii XXXXXXXXX
guest-mode
exit
interface dot11Radio 0
encryption mode ciphers aes
ssid Wireless Network
channel 13
no shutdown
exit
int bv1
ip add dhcp
desc LAN-interface
end
write
Sources:
Lightweight to Autonomous (vice versa) Conversion…
http://itsnippet.com/2016/01/10/converting-cisco-ap-from-lap-to-autonomous/
https://supportforums.cisco.com/discussion/10937886/reset-factory-default-doesnt-work-1142-ap